Power outages and backup power
Power Surge - What It Is, How to Tell You Had One and What to Protect First
Updated October 10, 2026 - 8 min read - Rainy Day Plan
The short answer
A power surge is a jump in voltage to hundreds or thousands of volts that lasts a few millionths of a second. Lightning causes it, and so does switching: loads turned on or off at home or on the grid. It's too fast to see. You find out later, when something won't turn on. Check devices with two wires first: power plus cable or phone.
What you noticed, and what it most likely was
A wall outlet is meant to sit near 120 volts. The spike is gone thousands of times faster than a blink, so nobody sees a power surge happen. You see what came with it. Sometimes that's an outage: power can come back with surges or spikes, which is why unplugging is an early step in what to do when the power goes out.
Find your row.
| What you noticed | What it most likely was | What it means for your devices |
|---|---|---|
| Lights dimmed for a moment, a clock is blinking, the computer restarted | A sag: the voltage fell below normal for a moment | Unlikely to damage most appliances. Sags happen more often than outages |
| The power blinked off and on in a split second, once or a few times | The utility's automatic breaker reacting to a fault, such as a tree limb or an animal on the line. It disconnects for an instant, and that causes a surge. If the fault hasn't cleared after the third time, it locks out and the power stays off | The grid working as designed, and a surge all the same. Run the check below |
| The power came back after an outage | It may return with momentary surges or spikes | Whatever stayed plugged in took them. Run the check below |
| Thunder close by, and the lights blinked or the computer restarted | A lightning surge that came in along the power line, the phone line or the TV cable. A direct strike on the house is rare | Video equipment and computers connected to a modem are the most often damaged in lightning storms. Start with those |
| Nothing at all, yet one device won't turn on | Maybe a switching surge: a load in the house turned on or off, by a hand on a switch or by an appliance's own controls, or the power company's normal operations. Maybe a surge that came in on the phone or cable wire and not the power line. Or the device just failed | Look at what else shares that device's wires |
What to check in the next 10 minutes
The check is the same whichever row was yours. If you smell something burning, see sparks or hear sizzling or buzzing from an outlet or the panel, get everyone out and call 911 before any of this.
- Turn on each device that has two wires: the modem, the cable or satellite box, any TV with a cable in the back.
- Try what's wired through the house: garage-door opener, alarm panel, sprinkler timer, intercom. These are the most sensitive devices in the house.
- Try the appliances with a keypad or a display. Electronic controls are more easily damaged than a mechanical dial, and a surge can also upset the memory of anything programmable.
- Look at the light on every surge protector. The lights aren't standardized, so check the instructions for what yours means. When protection fails, some units cut the power to whatever is plugged in. Others keep the power flowing with no protection left.
- Open the breaker panel. If a breaker tripped during an outage, have an electrician inspect it before you switch it back on.
- Press the test button on each hardwired smoke alarm and carbon monoxide alarm, and on every outlet that has test and reset buttons. A surge can hurt the electronics inside them, and the damage would likely go unnoticed.
- Leave anything dead unplugged. In case of an insurance claim, photograph it before any repair and keep it for the adjuster to inspect. Photograph its label too, and write down the date and time.
Which protector covers which device
Count the systems a device is wired to, then find its row. The rule is about wiring, so it works on anything you own.
| What you own | Its wires | What protects it |
|---|---|---|
| Lamp, toaster, space heater, washer with a dial | Power only, no electronics | Usually nothing. Mechanical controls generally withstand typical surges, and for a lamp a protector costs more than a new lamp |
| TV with no cable in the back, radio, microwave, computer with only a power cord | Power only | A plain plug-in protector. Quite often the maker has built protection in already |
| Fridge, dishwasher or washer with a keypad or display | Power only, electronic controls | A plain plug-in protector where you can reach the outlet, or one at the breaker panel |
| Modem, cable or satellite box, TV with a cable in the back, computer on a phone line | Power plus phone, cable or satellite | One combined protector that both wires pass through |
| Hardwired smoke and carbon monoxide alarms, outlets with test and reset buttons | Wired straight into the house | Nothing you can plug in. A protector at the panel is what reaches them |
| Alarm system, garage-door opener, sprinkler timer, intercom | Power plus signal wires around the house | These belong with the two-wire devices. For an alarm system, protection should be part of the design, so ask the installer. With a new opener or alarm system, ask about surge protection before you sign the contract |
| Well pump outside the house | A power line that leaves the house | Its own protector at the point where that line leaves the house |
Two wires change things. A surge on either system creates a voltage difference between the two, and that difference can damage the device even when each line has a protector of its own. The fix is a single protector that both wires pass through. You can tell one by the pair of coax connectors or phone jacks next to its outlets. Check which jack is marked in and which is marked out.
A protector at the panel, strips at the devices, or both
A single protector where the power enters the house is enough for power-only devices but not for two-wire ones. So every two-wire device in the house gets its own combined protector, with or without anything at the panel. A panel protector is for what a strip can't reach, and for the heavy hits: its job is to divert large surges on the power line before they enter the house.
Before you pay for a panel protector, find out whether there's one already. Since its 2020 edition the National Electrical Code has required one in every home, at or right next to the service equipment, when a new service goes in or an old one is upgraded. A newer home, or one whose service was upgraded since, may have it. Some power companies also offer a type that mounts at the meter.
A strip doesn't reach far. It may help other outlets on its own branch circuit, but much less on other circuits, so give each sensitive device a protector of its own.
Example, a made-up household. A cable modem in the hall, a TV on the same cable in the den, a fridge with a display, hardwired smoke alarms and a toaster. The modem and the TV each get a combined protector with coax connectors. The fridge gets a plain plug-in protector if its outlet can be reached. Only a panel protector covers the smoke alarms, so this house has a reason to ask an electrician about one. The toaster gets nothing.
Unplugging ahead of a storm is the other route, and it's worth considering. It's no help when nobody is in the house, though. For a two-wire device, think twice before pulling just the power cord: the cord is also the device's ground, and you'd lose it right when a surge may arrive on the phone or cable line. A combined protector is there either way.
Reading a surge protector's package
- Look for the mark of a product-testing lab, such as UL, ETL or CSA.
- Joules measure the surge energy a protector can take, and typical values run from about 100 to 1,000 or more. Maximum surge current may tell you more. It runs from several hundred to several thousand amperes, and even the lower values on offer are enough for most surges.
- Clamping voltage is often printed as 330 volts. That isn't a requirement. 400 volts or more may be enough for electronics, and it leaves the protector less likely to be damaged by a swell, a short stretch of high voltage.
- You can ignore speed of response.
- Find out what the unit does when its protection fails: cut the power, or keep the power on unprotected. We'd take the cut-off for a computer and the power for a freezer.
- Price is no guide. Don't buy the most expensive one assuming it protects better.
A protector works by diverting the surge to ground, so the best one can be useless where the grounding isn't right. And none lasts forever. Their parts age, and one exceptionally large surge or a stretch of very high line voltage can end a protector's life early. The indicator light, where a unit has one, is how you find out. If the package has a card that explains the light, save it: the meaning isn't always clear on the unit itself. Have the protectors for your household electronics in place before an outage, and look at each light then. Surge protectors are one line on our power outage emergency kit list.
A UPS is a different box: a small battery that carries a computer through sags and short outages, often with surge protection built in.
Who pays for what a surge ruined
Usually not the power company. Limits on what electric utilities have to pay for are very common. In Maryland, for example, a utility isn't required to pay customers back for appliances or electronics damaged by an outage or a surge, unless willful default or neglect caused it. The regulator there may send a damage dispute on to the customer's insurer or the courts. Ask your own state's utility regulator for its rule.
Homeowner insurance usually covers appliances and electronics that a power surge ruins, even when no outage was involved. The catch is the deductible. With old or low-cost equipment, a claim may not be worth filing. So compare first: if the dead device would cost less to replace than your deductible, there's nothing to claim. If it costs more, the photos from your 10-minute check go to your insurer.
If you rent, your landlord doesn't insure your belongings. A renter's policy does, and it typically covers loss or damage from electrical surges.
The panel and the two-slot outlet
- Work at the breaker panel is best left to a licensed electrician, and a protector at the meter needs the power company.
- Surge or no surge, call a licensed electrician when lights keep flickering, breakers trip often, or a plug, cord or switch feels unusually warm. A warm or discolored outlet is an electrician's job too.
- A combined protector may not work well through a two-prong adapter, because the adapter usually leaves it without a ground. A two-slot outlet is a reason to ask the electrician about a grounded one.
Sources
Every number in this article comes from these public sources, and we checked each one before it went up.
- NIST - Surges Happen! How to protect the appliances in your home, Special Publication 960-6, May 2001, PDF
- NIST - Surges Happen!, the full text of the same publication at the Internet Archive
- NFPA - Changes to the 2020 NEC that impact how we install residential electrical services, blog by Corey Hannahs, April 2021
- Maryland Public Service Commission - Consumer FAQs
- Washington State Office of the Insurance Commissioner - Winter weather and insurance coverage
- Ready.gov (FEMA) - Power outages
- Ready.gov (FEMA) - Thunderstorms and lightning
- American Red Cross - Power outage, before, during and after
- US Fire Administration - Severe weather fire prevention
- US Fire Administration - Appliance and electrical fire prevention
- Texas Department of Insurance - Tips for filing a claim with your insurance company
- New York State Department of Financial Services - Renter's insurance
- Massachusetts Department of Fire Services - Hot weather reminder, plug air conditioners directly into wall outlets, news release, May 2022
- University of Illinois Extension - Respect electricity's potential wrath, news release, May 2020




































