Water
Bleach to Water Ratio for Drinking - The Amount for Every Container, by the Strength on Your Label
Updated October 12, 2026 - 4 min read - Rainy Day Plan
The short answer
The bleach to water ratio for drinking is 8 drops of 6% bleach, or 6 drops of 8.25%, per gallon of clear water. Use plain unscented bleach that's less than a year old. Stir, wait 30 minutes, and you should notice a faint chlorine smell. For cloudy, colored or very cold water, double the amount.
Read the label before you count drops
Bleach is one of three ways to treat water. When to pick it over boiling or a filter is covered in how to purify water at home.
The ratio depends on what's in your bottle, so start there. Go down the rows and stop at the first one that fits:
| Your label says | Use |
|---|---|
| Directions for disinfecting drinking water | Those directions |
| Scented, color-protecting, or with added cleaners | Nothing. That bottle isn't for drinking water |
| 6% or 8.25% | The table below |
| 5.25% | The 6% column. A spoon gives the same answer: 1/8 teaspoon a gallon for 5.25% to 6% |
| Another strength from 5% to 9% | 8 drops a gallon |
| 1% | 40 drops a gallon, five times the usual count |
| No percent anywhere | Don't guess. Boil the water instead, or buy a bottle that says |
Then check the age. Bleach loses strength sitting on a shelf, so use bleach that's been kept at room temperature for less than a year. Write the purchase date on the cap with a marker. If the bottle in your kit has no date, replace it.
The amount for your container
Stronger bleach needs fewer drops. Read down the column that matches your label.
| Water to treat | 6% bleach | 8.25% bleach |
|---|---|---|
| 1 quart or 1 liter | 2 drops | 2 drops |
| 2-liter soda bottle | 4 drops | 4 drops |
| 1 gallon | 8 drops | 6 drops |
| 2 gallons | 16 drops | 12 drops |
| 5-gallon jug | 40 drops | 30 drops |
| 8 gallons | 2/3 teaspoon | 1/2 teaspoon |
| 55-gallon drum | 4 2/3 teaspoons | 3 1/2 teaspoons |
Any other size works the same way, by adding up rows: the soda bottle is two quarts' worth, the 5-gallon jug five gallons' worth, and the drum seven 8-gallon batches (our arithmetic). For filling a drum from a well, the 55 gallon water drum page has the whole fill.
No dropper? You've got two other routes:
- Anything marked in milliliters: 1/2 mL a gallon for bleach from 5% to 9%.
- A measuring spoon: 1/8 teaspoon a gallon of 5.25% to 6% bleach. For a quart, the amount is too small to measure with a spoon, so use drops.
Cloudy water: clear it, then double it
Bleach works worse in dirty water. If the water is cloudy, let it stand until the dirt settles and pour off the clear part, or strain it through a clean cloth or coffee filter. Then double the amount from the table, since the water's still cloudy, colored or cold.
A labeled example. A 5-gallon jug of well water that came out murky after a storm, and an 8.25% bottle. Let the dirt settle, then pour the clear water into a clean jug. The table says 30 drops for 5 gallons. Doubled for cloudy water, that's 60 drops.
Water with things floating in it, a dark color or an odd smell is a different case: don't use it at all.
Wait, then smell
- Add the bleach and stir, or cap the container and shake it.
- Wait 30 minutes.
- Smell it. A slight chlorine smell means it's done.
- No smell? Add the same amount again and wait 15 more minutes.
- Still nothing after that? Pour it out and find other water.
Three bleach mixes people mix up
The drinking amount is tiny on purpose. Two other bleach mixes show up in the same emergency instructions, and both are far stronger:
| Mix | Bleach | Water | Compared with drinking water |
|---|---|---|---|
| Drinking water, 5% to 9% bleach | a little under 1/8 teaspoon | 1 gallon | 1 time |
| Dish soak during a boil water advisory | 1 teaspoon | 1 gallon of warm water | about 8 times stronger |
| Sanitizing an empty storage container | 1 teaspoon | 1 quart | about 32 times stronger |
The last two never go into water you drink. Keep them in a basin or bucket with a label, and pour them out when the job is done.
What bleach won't do
Bleach kills viruses and bacteria, but it may not kill parasites. For lake, river or stream water, filter first or boil; see does boiling water purify it for what heat can and can't fix. And no amount of bleach fixes water with fuel or toxic chemicals in it. Use stored or bottled water instead.
Questions people ask
Can I treat water now and store it for later?
Yes. Put the treated water in clean, sanitized containers with tight covers, label them with the date, and swap them every 6 months like any water you fill yourself. Tap water from a utility that chlorinates it doesn't need bleach before you store it.
Sources
Every number in this article comes from these public sources, and we checked each one before it went up.




































