Weather and disasters
What to Do If a Pipe Bursts - The First Hour, Step by Step, and the Two Days After
Updated October 12, 2026 - 6 min read - Rainy Day Plan
The short answer
If a pipe bursts, close the main water shut-off valve first, then turn off the water heater. Stay out of water that touches outlets, cords or appliances. Open the faucets so the pipes drain through them instead of the crack, and call a licensed plumber. Then dry everything that got wet within 24 to 48 hours, before mold can grow.
Minute one: find the valve and close it
Keeping a pipe from splitting in the first place is in the guide to keeping pipes from freezing. This page starts once water is already on the floor.
| Where to look for the main valve | What you'll see |
|---|---|
| Where the water line comes into the house, often at the front near the hose faucet | A round handle or a lever on the pipe |
| Basement, near the water heater, or in the garage | Same, usually low on the wall |
| Outdoors near the foundation | A valve on the pipe before it enters the wall |
| Near the water meter | A valve on each side of the meter in many homes. Close the one on the house side |
Turn a round handle clockwise until it stops. A lever goes a quarter turn, so it ends up across the pipe.
Valve stuck, or you can't find one? Close the valve in the meter box instead, with a wrench or a meter key, turning it clockwise. Can't get at that either? Call your water utility's emergency line and ask for an emergency shut-off. In an apartment, call the property manager. The valve may be somewhere you can't reach.
Just one fixture leaking, such as a toilet supply line or the pipe under a sink? The small valve on that line may stop it. Close the main anyway if you're not sure.
Minutes 1 to 5: the water heater and the power
Turn off the water heater next. On an electric one, that's its breaker in the panel. On a gas one, turn the control to off or pilot, as the label on the tank shows. Then close the valve on the cold-water pipe going into the top of the heater.
Then the electricity. If you can reach the breaker panel on a dry floor, turn off the circuits for the wet rooms. If the panel is in the wet area, leave it and call an electrician or the power company.
Minutes 5 to 20: drain the lines and move things
Shutting the main doesn't empty the pipes. Open the faucets, hot and cold, upstairs and down, and let what's left run out through them instead of through the split.
Set pots and buckets under drips. Pick up rugs, papers, electronics and anything on the floor, and carry it to a dry room. Lift furniture legs onto blocks or foil so they stop soaking up water.
Before you mop, take photos or a short video of each wet room and the broken pipe. Once everything is moved and dry, it's hard to show a plumber, a landlord or anyone else who asks later what got wet and where.
Minutes 20 to 60: who to call
| Call | When |
|---|---|
| A licensed plumber | Every time. Say whether the pipe is copper, plastic or galvanized and where the split is, so they bring the right fittings. Leave the main off until it's done |
| Landlord or building manager | You rent, or the valve is in a shared space |
| Your water utility | The leak is at the meter or on the street side of it, or you couldn't close the main |
| An electrician or the power company | Water reached the panel, outlets or wiring |
| A cleanup company that handles dirty water | The water came from a drain or sewer line, not a supply pipe. Sewage soaks into drywall and carpet, and those usually have to come out |
Living with the main off
Until the repair, the house runs on stored water. Fill the toilet tank from a bucket to flush, and drink from bottled or stored water. How much a household needs a day is on emergency water storage.
The first two days: dry it out
Dry the wet areas within 24 to 48 hours and in most cases mold won't grow. That's your clock now.
- Get the standing water out first: mop, buckets, a wet vacuum.
- Run fans and open windows if the weather allows. A dehumidifier helps in a closed basement.
- Scrub hard surfaces with detergent and water and dry them completely.
- Carpet, ceiling tiles and other materials that soak up water may have to be thrown out if they turn moldy.
- A patch of mold under about 10 square feet, roughly 3 feet by 3 feet, is something most people can clean up themselves. A bigger area, or a lot of water damage, calls for someone experienced in mold cleanup.
- Don't run the heating and cooling system if you think mold got into it. It can spread mold through the house.
Power out too? Heat, light and food during the outage are on what to do in a power outage.
When the water goes back on
Once the plumber is done, open a faucet and turn the main back on slowly. Then walk every room and look at the pipes and the meter for new drips. A crack may only show once the ice melts, and the cold that split one pipe can crack another, so don't stop at the one that was fixed.
Don't power the water heater up empty. First reopen the valve on the cold-water pipe into the heater, the one you closed in the first minutes. While it's shut, the tank can't refill. Then run a hot faucet until the water comes out steady, with no sputtering air, and only then switch the breaker on or relight the gas as the label says.
Frozen, not leaking yet
A faucet that gives only a trickle on a cold morning is the first sign of a frozen pipe. Find the main valve before you warm anything, so you're ready if a crack shows up as the ice melts. Keep that faucet open. Never use an open flame or a torch on a pipe. The full thawing steps are in the pipes guide.
Wet floors, live wires and a sagging ceiling
Never touch electrical equipment that's wet, or anything electrical while you're standing in water. A ceiling that sags with water can come down, so keep everyone out from under it. And keep children and pets out of water from a drain or sewer line.
Questions people ask
The water is coming from inside a wall or ceiling. How do I find the leak?
Close the main first, whatever you can or can't see. To check for a hidden leak later, read the water meter, use no water for two hours and read it again. If it moved at all, there's probably a leak. Finding the exact spot behind a wall is the plumber's job.
Can I turn the water back on for the rest of the house before the plumber comes?
Only if a valve between the main and the break closes off that line, like the small valve under a sink or behind a toilet. If the break is on a pipe with no valve of its own, the main stays off until the repair.
Sources
Every number in this article comes from these public sources, and we checked each one before it went up.
- Portland Water Bureau - What to do if water pipes freeze, leak or burst as temperatures rise, January 16, 2024
- City of Bellevue, Washington, Utilities - Prevent frozen pipes, and if one breaks
- Philadelphia Water Department - All about frozen pipes
- University of Illinois Extension - Water pipes
- EPA - A brief guide to mold, moisture and your home
- EPA WaterSense - Fix a Leak Week
- Ready.gov (FEMA) - Floods




































