Weather and disasters
Box Fan Air Purifier - Build One for Smoke, or Size One From the Label
Updated October 17, 2026 - 6 min read - Rainy Day Plan
The short answer
A box fan air purifier is a 20-inch box fan with a MERV 13 furnace filter fixed to its back. Against wildfire smoke it can stand in for a store-bought cleaner for the short term. Add a cardboard shroud on the front. In tests, one filter with a shroud covered a room of about 155 square feet, and four filters in a cube about 400.
Build it: a box fan, a MERV 13 filter and a shroud
If you can't get or afford a store-bought cleaner, a box fan with a furnace filter can run the cleaner-air room in our wildfire smoke plan: one closed room where everyone breathes and sleeps on smoky days. It's a stopgap, not a permanent fix.
- Use a 20-inch box fan made in 2012 or later, with a testing-lab mark on the label. Newer fans have a fused plug and a cutoff that trips when the motor overheats.
- Get a 20-by-20-inch MERV 13 furnace filter, 1 or 4 inches thick.
- Fix the filter to the back of the fan with clamps, duct tape or bungee cords, with its airflow arrow pointing at the fan.
- Add a cardboard shroud on the front: a sheet over the fan's face with a circle cut out for the blades, so the corners are covered.
- Plug it straight into the wall. No extension cord, no damaged fan, and no kids left alone with it running. A fan made before 2012 should never run unattended or while you sleep.
How big a room each build covers
Measure the room, then pick the build whose last column covers it. The middle column is each build's smoke CADR from tests, meaning how much filtered air it puts out. For the room sizes we used the wildfire target from the math further down: a smoke CADR equal to the room's square feet.
| Build | Smoke CADR | Room it covers at the wildfire target |
|---|---|---|
| One 1-inch filter | 111 | About 110 sq ft |
| One 1-inch filter plus a shroud | 156 | About 155 sq ft |
| One 4-inch filter plus a shroud | 248 | About 250 sq ft |
| Two 1-inch filters plus a shroud | 263 | About 260 sq ft |
| Four 1-inch filters built into a cube, plus a shroud | 401 | About 400 sq ft |
The shroud alone added about 40 percent. One filter with a shroud suits a small bedroom, and the four-filter cube can cover a family room. Say your bedroom is 12 by 15 feet, so 180 square feet: one filter with a shroud (about 155) comes up short of the target, and a 4-inch filter with a shroud (about 250) covers it. A box fan is louder and warmer than a store-bought cleaner, which you'll notice in a closed bedroom on a hot night.
With a box fan, check the filter every day in smoke. Change it when it turns dark brown or gray, smells of smoke or looks dirty, and again once the smoke event is over. In tests, box-fan cleaners with dirty filters did almost nothing.
Buying one instead: the number on the label
A store-bought cleaner does the same job in the same closed room. Boxes promise "large rooms" and "whole home", and you can't compare those. You can compare the CADR, the clean air delivery rate: how much filtered air the cleaner puts out, usually measured at its top speed.
Most labels show three CADRs, for tobacco smoke, dust and pollen. They stand for small, medium and large particles. Wildfire smoke is the small kind, so the smoke number is the one to read.
The math for your room
- Measure the room. A bedroom 12 by 15 feet is 180 square feet.
- Find the minimum: two-thirds of the square feet. 180 x 2/3 = 120.
- Find the wildfire target: the full square feet. Here that's 180.
- Check the ceiling. Both rules assume 8 feet. Higher ceilings need a bigger CADR. Our own math for that: multiply by the ceiling height, then divide by 8. Under a 10-foot ceiling, the bedroom's target becomes 180 x 10 ÷ 8 = 225.
With an 8-foot ceiling, that bedroom needs a smoke CADR of at least 120, and 180 is the number to shop for. If heavy smoke comes often where you live, going higher still makes sense.
| Room | Example | Minimum smoke CADR | Wildfire target |
|---|---|---|---|
| 100 sq ft | 10 x 10 ft bedroom | 67 | 100 |
| 200 sq ft | 10 x 20 ft bedroom | 133 | 200 |
| 300 sq ft | 15 x 20 ft living room | 200 | 300 |
| 400 sq ft | 20 x 20 ft family room | 267 | 400 |
| 500 sq ft | 20 x 25 ft great room | 333 | 500 |
| 600 sq ft | 20 x 30 ft open room | 400 | 600 |
Test the room size printed on the box
Makers print a room size too. Check it by working backward from the smoke CADR: a smoke CADR of 200 covers a room of up to 300 square feet by the basic rule, but only 200 square feet at the wildfire target. For smoke, trust the smaller number.
A big open floor plan is hard to cover: 900 square feet needs a smoke CADR of 600 just for the minimum. Closing a door and cleaning one room well is usually the better trade.
What else to check before you buy
- A HEPA or other high-efficiency filter, which traps the particles without making ozone.
- No ozone. Skip ozone generators outright. Ionizers, electrostatic plates and some UV lights can give it off too, and it irritates the lungs. If you're looking at an electronic cleaner, check it against California's list of models that pass the state's ozone limit. That list checks ozone, not how well they clean.
- Carbon, if the smell bothers you. CADR counts particles only, and the smell is gases. For that you need an activated carbon filter with a lot of carbon in it. There's no common rating for it, so don't take odor claims at face value.
- Noise you can live with all night. The CADR is earned at top speed, so a cleaner one size up can run a notch lower and still keep pace.
- Replacement filters you can actually find, since over a season they're most of what you'll spend.
To compare two models, line up the smoke CADR against your room, the replacement filter and how easy it is to buy, and the noise at the speed you'd run overnight.
Running it on a smoky day
Run it in the closed cleaner-air room from the wildfire smoke plan, nonstop on its highest setting if you can. Pull it out of the corner and give it room on every side, so nothing blocks the airflow.
A cleaner only helps while it has power. If an outage is likely, a portable power station can keep a small cleaner going; the watts are on its label. And a closed room gets warm. When it's too hot to stay in, cooling a room without AC covers when to go somewhere cooler.
Change filters more often in smoke
Heavy smoke loads a filter fast, so plan on changing it sooner than the maker's schedule says. Keep at least one spare per cleaner in the closet before the season starts. During a long smoke event, check it often. If it looks dirty, change it.
Central air: switch the fan to On
If you have central heating or cooling, a filter rated MERV 13 to 16 can cut indoor particles by as much as 95 percent. Not every system can take one, so ask a heating and cooling technician first.
The filter only works while the fan runs, and most systems run less than 25 percent of the time. Set the fan to On instead of Auto. That switch alone has cut particles by as much as 24 percent. Use the recirculate setting, so the system isn't pulling smoky air in from outside.
Sources
Every number in this article comes from these public sources, and we checked each one before it went up.
- EPA - Guide to air cleaners in the home
- EPA - Wildfires and indoor air quality
- EPA - Create a clean room to protect indoor air quality during a wildfire
- EPA - Research on DIY air cleaners to reduce wildfire smoke indoors
- AirNow (EPA) - Wildfire smoke factsheet, indoor air filtration
- ENERGY STAR (EPA) - An air cleaner can be helpful in high-risk wildfire areas
- AHAM, Association of Home Appliance Manufacturers - Air filtration standards
- California Air Resources Board - List of CARB-certified air cleaning devices




































